Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Before
After
Before
After
Before
AfterPGT Impact Garage Doors: The Weston Owner’s Guide
We stock and install PGT-compatible impact garage doors in Weston, with typical installed pricing from $2,800 to $5,400 depending on size, wind-load rating, and hardware series. Most standard single-car replacements can be surveyed and quoted same-week, with the written price delivered before any work begins. Most Weston homeowners discover a problem when the door hangs uneven in the track, the opener strains audibly, or they notice daylight seeping past a warped bottom seal after a storm cycle.
Which PGT Models This Applies To
PGT’s impact garage door line breaks into two series relevant to Weston homes: the PGT Windguard residential series and the heavier PGT Commercial Impact line found on some townhome associations along Bonaventure Boulevard. The Windguard uses a 2-inch track with proprietary roller spacing; the commercial line steps to 3-inch heavy-gauge track with reinforced hinges at 18-inch centers. You will find the series label on a stamped metal tag inside the top section of the door, usually right of center, or on the track itself near the flag bracket.
Matching matters because PGT’s impact-rated panels are laminated with interlayer thicknesses that vary by series. A Windguard panel will not carry the same DP rating if hung on commercial hardware, and the glazing bead profiles differ enough that swapping between them leaves gaps at the corners. We carry OEM PGT track, rollers, and hinges, plus a tested aftermarket line from a Florida manufacturer that meets the same DP-50 rating at roughly 15% lower parts cost. The aftermarket option carries the same 365-Day Done Right Promise, but we will note it on the written quote so you see the distinction before signing.
Signs Your PGT Impact Garage Door Is Failing
- The door shudders or binds in the first 12 inches of travel. This usually means a cracked roller wheel or a bent track section at the curve. In Weston, we see this most often on doors facing west toward the Everglades, where afternoon thermal expansion stresses the metal.
- Visible gaps at the perimeter seal after the door closes. The rubber bulb seal hardens in Florida’s UV and salt air, losing compression memory. On homes near Weston Town Center, we replace these every 4 to 6 years, sooner if the garage faces open water exposure.
- The opener motor labors or reverses unexpectedly. A binding hinge or a sprung panel section increases load beyond the opener’s torque limit. The motor is protecting itself, but the underlying mechanical fault will worsen.
- Dented or delaminated panel faces, especially at the bottom. Impact-rated panels are built to flex and return, but repeated low-speed impacts from landscape equipment or basketballs fatigue the aluminum skin. Once the interlayer separates from the face sheet, the panel loses its missile-impact rating.
- Corrosion at the bottom fixtures or flag brackets. Galvanized hardware in Weston garages lasts roughly 8 to 12 years before red rust appears at the welds. We upgrade to stainless bottom fixtures when we replace them, which doubles the service interval.
Before
AfterReplacement Cost & What’s Included
| Component | Price Range (Installed) |
|---|---|
| Single 8’×7′ PGT Windguard door, standard hardware | $2,800 - $3,600 |
| Double 16’×7′ PGT Windguard door, standard hardware | $4,200 - $5,400 |
| Panel replacement (1-2 sections, Windguard) | $680 - $1,200 |
| Track and roller hardware set (OEM) | $340 - $520 |
| Bottom seal replacement, labor included | $180 - $260 |
| Stainless bottom fixture upgrade | $90 - $140 per pair |
The range depends on three factors: door size, wind-load rating required by your Weston building zone, and whether the existing opener can handle the weight of a new impact-rated assembly. We measure every opening with a laser level and record three reference points per jamb. The written quote you receive is generated from that survey and cannot change unless you add scope. Every replacement includes permit research, debris removal, and the documented photo record under Haven Clause 4.
DIY or Call Us?
A homeowner can safely inspect the door for obvious damage, test the manual release, and listen for where the binding occurs. What we do not recommend is removing or adjusting the torsion spring system. PGT impact doors are heavier than standard residential doors, and the spring is calibrated to that mass. A released spring carries enough force to cause serious injury or property damage. We have replaced doors in Weston where a well-intentioned owner bent the track worse trying to force a misaligned roller back in.
If you are unsure whether the fault is in the panel, the hardware, or the opener, we offer a free second opinion on any written estimate you have already received. Bring us the competitor’s scope and we will review it against what we find in your opening. Call (754) 812-9260 to schedule a measured survey.
FAQs
In coastal Broward conditions, a properly installed PGT Windguard door lasts 15 to 20 years before the panel interlayer begins to degrade. The hardware and seals need attention at roughly half that interval. Call (754) 812-9260 for an exact condition assessment, estimates are free.
Individual panels, rollers, and seals can be replaced if the door structure and track are sound. Once two or more panels are damaged or the track is out of plumb beyond 1/4 inch, replacement is more economical than repeated repairs. Call (754) 812-9260 for a written scope and price.
A standard single-car PGT Windguard replacement takes one working day from removal to final adjustment, assuming no framing repairs are needed. Double doors or commercial-series units may extend to a second day for hardware alignment and testing. Call (754) 812-9260 to schedule.
We carry Windguard rollers, hinges, bottom fixtures, and seals on every service vehicle. Full door panels and track sections are ordered to size after measurement, since PGT builds to specification rather than maintaining a standard warehouse inventory. Call (754) 812-9260 to confirm availability for your series.
Sightline Windows & Doors Weston is an independent service provider, not affiliated with PGT Industries. We also stock and install parts for CGI, CWS, and ES Windows impact garage door systems.
Sonia Raman, who leads our crews, grew up in Miami and started in glazing through the shop programs at Miami Dade College before running residential jobs across Broward County for the better part of two decades. She has logged enough hours on Weston retrofits, particularly along the Town Center corridor where salt-laden air finds every bad seal, that she keeps a running record of product failures by pattern. “Measure it right the first time. The window does not care how confident you were.” That habit of checking every frame from three reference points before calling it square has saved more than one costly re-order.
Every job we take in Weston is governed by the Haven Standard: the written price before any tool is lifted, the verified crew identified by license number, the documented photo record when the job is done, and the 365-Day Done Right Promise if anything falls short.
Written by Sonia Raman, Owner, Sightline Windows & Doors Weston at Sightline Windows & Doors Weston, serving Weston and nearby areas.